Ricoh PRIPORT JP730 User Manual download pdf (Page 155)

5. Remarks

Operation Notes

General Cautions

• While printing, do not turn off the main switch.

• While printing, do not open the door or covers.

• While printing, do not unplug the power cord.

• While printing, do not move the machine.

• Keep corrosive liquids, such as acid, off the machine.

• Open and close the door and covers softly.

• Do not put anything except originals on the machine.

• Do not spill liquid on the machine.

•

When opening or closing the door or covers, keep hold of them so they do not fall.

• When removing the drum unit from the machine, be careful not to let the

drum unit fall.

•

Do not modify or replace any parts other than the ones specified in this manual.

• Do not operate the machine without covers. You might get your fingers

caught in the machine, or the machine might be damaged because, for exam-

ple, dust or the like might get inside.

• Since some parts of the machine are sharp and might cause injury, touch only

the parts specified in this manual.

• If you clean rubber parts with alcohol, wipe them with a dry cloth afterwards.

• Always turn the machine off when you have finished printing for the day.

• If the machine must be transported by vehicle, please contact your service

representative.

• Always make trial prints to check the image position because the image posi-

tion of the trial print might not correspond with that of the original.

• If image registration is not consistent, slow down the printing speed.

• When doing bicolored or multicolored printing, leave the printed paper for a

while before the next printing in order to let the ink dry on the printed paper.

If this is not done, feed roller marks will appear on the print image.

• If the machine has not been used for a long period, the ink may dry up caus-

ing image density to decrease. In such a case, select the slower printing speed

and make extra prints until the image density recovers.

• When the machine is used in low temperature conditions, the image density

might decrease. In this case, select the slower printing speed.

•Press the {Proof} key to perform a test print as the first few prints might be

light.

Titanium2_EN-F2_FM_forPaper.book Page 67 Wednesday, January 25, 2006 6:30 PM

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 170 171

No comments

Ricoh PRIPORT JP730 User Manual Page 155