Ricoh Pro C651EX Specifications Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 81
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
Product Support Guide
D075 / D074 / M044
Ver. 1.5 Page 11 of 81 8/8/2013
Subject to change without notice
Installation
Installation Requirements (Environment)
Temperature Range:
Recommended Temp. 23° C (73.4° F). Allowed Range: 10° C to 32° C (50° F to 89.6° F)
Humidity Range: 15% to 80% RH
Ambient Illumination: Less than 1,500 lux (do not expose to direct sunlight)
Ventilation: 3 times/hr
Ambient Dust: Less than 0.10 mg/m
3
(2.0 x 10-6oz/yd
3
)
Avoid areas exposed to sudden temperature changes:
Areas directly exposed to cool air from an air conditioner.
Areas directly exposed to heat from a heater.
Do not place machine where it will be exposed to corrosive gas or vapor.
Do not install the machine at any location over 2,000m (6,500 ft.) above sea level.
Place the machine on a strong and level base.
Do not place the machine where it may be subject to strong vibrations.
Machine level
Front to rear = Less than 5.0 mm (0.2") away from level
Right to left = Less than 5.0 mm (0.2") away from level
Notes:
If the machine is installed in a location where the ambient temperature is more than 30°C (86°F): (1) Do not run full color
printing longer than 2 hours, and (2) never turn the main power switch off immediately after a long print job. Leave the
machine on so that the fans can expel the hot air from the machine and cool the electronic components.
If this machine is to be used in a high temperature and high humidity condition, the tray heater is required to get the proper
print quality. Connect the tray heater harness during the mainframe installation.
Do not connect the machine to the same power source as other electrical devices.
Leave the machine on so that the fans can expel the hot air and Ozone from the machine and cool the electronic
components.
Network connections (X2):
1. Fiery Controller:
a. Printing is only available via the Fiery controller.
b. WIM access to Fiery Controller Settings.
2. GW network connection.
a. Allows for @Remote connection.
b. Web Image Monitor connection to mainframe GW settings
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 80 81

Comments to this Manuals

No comments