Ricoh FW780 Operations Instructions download pdf (Page 86)

Troubleshooting

Do's & Don'ts

CAUTION:

• Do not touch areas on or around the fusing unit. These areas get hot.

• After copies are made continuously, the exposure glass may feel warm. This

is not a malfunction.

• The area around the ventilation hole may feel warm. This is caused by ex-

haust air and is not a malfunction.

• Do not turn off the main switch while copying. Before turning off the main

switch, make sure that copying is completed.

• The machine might fail to produce good copy images if there is condensation

inside caused by a temperature change.

• Do not open the covers of the machine while copying. If you do, misfeeds

might occur.

• Do not move the machine while copying.

• The supplier shall not be liable for any loss or damage resulting from a failure

of the machine, a loss of machine settings, or use of the machine.

• Do not place more than one sheet of paper at a time on the bypass table.

• Center your paper on the copy table using the size marks. Then slide the pa-

per straight into the copier until it stops.

• When copying to a long sheet of paper, lightly hold the sheet as the copier

pulls it in so that it goes in well.

• Do not make two sided copies.

• If you open the unit, make sure you close it within 5 minutes to keep light

from damaging the copy drum.

• When copying to sheets 35" ×45" (90 cm ×115 cm) or larger, make sure the pa-

per does not drag directly on the floor as the copier pulls it in. (You can spread

paper on the floor for this.)

• If your paper has an uneven or slanted edge, do not insert this edge in first.

• Do not make copies longer than 118 inches (3 m).

• Do not insert originals made of paper less the 52.3 g/m

(13.9 lb or 0.07 mm

thick). For such originals, please use the Carrier Sheet.

• When you move the machine, unplug the power cord from the

wall outlet to avoid fire or electric shock.

• When the machine will not be used for a long time, unplug the

power cord.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 96 97

No comments

Ricoh FW780 Operations Instructions Page 86