Ricoh PJ X3131 Owner's Manual download pdf (Page 25)

Operations

Turning the power off

Press the ON/STANDBY button.

When the setting of beep sound is [

], the projector beeps, and a message appears

on the screen, conﬁrming that you wish to shut off the power. To shut off the power,

press the ON/STANDBY button again. If you do not wish to shut off the power, wait for a

while without conducting any operations. This message will disappear after a moment.

(This operation is no longer valid after the message disappears.)

Press the ON/STANDBY button again.

When the setting of beep sound is [On], the projector

beeps, and the screen disappears, but the internal

cooling fan continues to operate. Then, the projector

goes into standby mode.

During cooling, the ON/STANDBY indicator ﬂashes.

While the indicator is ﬂashing, the power can not be

turned back on. There is no problem with unplugging

the power cord in this state.

Replace the lens cap.

After use, replace the lens cap.

Note

The projector consumes about 4.5W of power in standby. We recommend that you

unplug the power cord if you will not be using the projector for an extended period.

Precautions

When you wish to restart the projector again right after turning off the power, give the

lamp time (about 5 minutes) to cool before plugging it back in. If the lamp overheats, it

may fail to light.

Right after turning off the power, the unit may become very hot, especially air exhaust,

lamp cover or the bottom of the unit. Please handle with care to avoid burn injuries.



•

Control panel

Remote

control

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

No comments

Ricoh PJ X3131 Owner's Manual Page 25