Ricoh Priport DX 4545 Operations Instructions Page 125

  • Download
  • Add to my manuals
  • Print
  • Page
    / 144
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 124
119
6. Remarks
Operation Notes
General Cautions
While printing, do not turn off the main switch.
While printing, do not open the door or covers.
While printing, do not unplug the power cord.
While printing, do not move the machine.
Keep corrosive liquids, such as acid, off the machine.
Open and close the door and covers softly.
Do not put anything except originals on the machine.
Do not spill liquid on the machine.
When opening or closing the door or covers, keep hold of them so they don't fall.
When removing the drum unit from the machine, be careful not to let the
drum unit fall.
Do not modify or replace any parts other than the ones specified in this manual.
Do not operate the machine without covers. You might get your fingers
caught in the machine, or the machine might be damaged because, for exam-
ple, dust or the like might get inside.
Since some parts of the machine are sharp and might cause injury, touch only
the parts specified in this manual.
If you clean rubber parts with water, wipe them with a dry cloth afterwards.
Always turn the machine off when you have finished printing for the day.
If the machine must be transported by vehicle, please contact your service
representative.
Be sure to make a few trial prints to check the image position because the image
position of the trial print might not correspond with that of the original.
If the image registration is not consistent, slow the printing speed down to
Setting 1.
When performing duplex or multicoloured printing, leave the printed paper
for a while before the next printing in order to let the ink dry on the printed
paper. If this is not done, feed roller marks will appear on the print image.
If the machine is not used for a long period, the image density might decrease
because the ink on the drum might dry. Make extra prints until the image
density recovers.
When the machine is used in low temperature conditions, the image density
might decrease. In this case, slow the printing speed down to step 1 or 2.
Page view 124
1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 143 144

Comments to this Manuals

No comments