Ricoh AP3850C Service Manual download pdf (Page 84)

3-32 Color Calibration

For Port, select the COM port to which the EFI Densitometer 100 is connected.

11. Measure each color patch using the EFI Densitometer 100.

The Status ﬁeld of the Mousitometer Measurements dialog box indicates whether the

connection to the EFI Densitometer 100 was successful.

The EFI Densitometer 100 Measurements dialog box also provides a visual map of

your progress.

Begin with Strip A, placing the EFI Densitometer 100 directly on the Measurement

Page and directly over the ﬁrst color patch. Click the measurement button on the

EFI Densitometer 100 to take a reading. You must click the button the number of

times that you selected for Clicks Per Patch. If you selected multiple clicks per patch, it

is a good idea to move the EFI Densitometer 100 slightly after each measurement

while keeping it within the patch circle.

NOTE: For more accurate measurement, place a plain sheet of paper beneath the

Measurement Page to block underlying colors from being read by the

EFI Densitometer 100.

Continue measuring every color patch on the Measurement Page, being sure not to

skip a single patch.

NOTE: It is critical that you take the measurements in the order outlined in the

EFI Densitometer 100 Measurements dialog box and on the Measurement Page.

12. When all patches have been measured successfully, click Accept and skip to step 15.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 199 200

No comments

Ricoh AP3850C Service Manual Page 84