Ricoh SP 213w User's Guide download pdf (Page 13)

Check the result.

Connection has succeeded: ◆

When "Connected to the access point." is displayed, the connection has been estab-

lished.

Connection has failed: ◆

When "Failed to connect to the access point." is displayed, the connection has not been

established. Start again from the beginning.

Manual Setup

If you cannot ascertain the settings of the access point (router) being used or the access point

(router) does not support WPS, configure the wireless LAN settings manually.

Check the SSID and encryption key (WEP key/Passphrase) by referring to the manual of the •

wireless LAN access point (router) being used.

Ascertain the security method employed by the access point (router) being used. If you are •

unsure which security method is supported by the wireless LAN access point (router) being

used, refer to the access point (router) manual.

If DHCP is enabled, specify the wireless LAN settings over a wired connection, and then rees-•

tablish the connection using the wireless IP address.

Device availability

Control Panel No

Web Image Monitor Yes

Smart Organizing Monitor* Yes

* Before Smart Organizing Monitor can be used, it must be installed. For details about installation, see "In-

stalling the Software" in the Setup Guide and "Installing the Driver and Software" in the User Guide .

Using the Smart Organizing Monitor

Check that the wireless LAN access point (router) is working correctly.

On the [Start] menu, click [All Programs].

Click [Smart Organizing Monitor for SP xxx Series].

Click [Smart Organizing Monitor Status].

If the machine you are using is not selected, click [Connect Printer], and then select the

machine's model.

Click the [User Tools] tab.

Click [Printer Configuration].

Enter the access code, and then click [OK].

The default access code is "Admin". Enter "Admin" if it has not been changed. Case is sig-

nificant.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

No comments

Ricoh SP 213w User's Guide Page 13