Monitoring and Configuring the Printer
58
2
hostname
Use the “hostname” command to
change the printer name.
❖ View settings
msh> hostname
❖ IPv4 Configuration
msh> hostname “interface_
name ” “printer_name”
• Enter the printer name using up
to 63 alphanumeric characters.
• You cannot use a printer name
beginning “RNP” (in either up-
per or lower case).
• The Ethernet interface and IEEE
802.11b interface will have the
same printer name.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
❖ Initializing the printer name for each
interface
msh>hostname
“interface_name” clear
name
ifconfig
Use the "ifconfig" command to view
and configure TCP/IP (IP address,
subnet mask, broadcast address, de-
fault gateway address) for the printer.
❖ View settings
msh> ifconfig
❖ IPv4 Configuration
msh> ifconfig “interface_
name” “parameter” “address”
• If you did not enter an interface
name, it is automatically set to
the Ethernet interface.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
The following explains how to
configure an IPv4 address
192.168.15.16 on Ethernet inter-
face.
msh> ifconfig ether 192.
168.15.16
❖ IPv6 Configuration
msh> ifconfig ether inet6
interface_name ”
“printer_name”
The following explains how to
configure a IPv6 address to
2001:DB8::100 with prefix length
64 on the Ethernet interface.
msh> ifconfig ether inet6
2001:DB8::100 64
Interface name
Interface configured
ether Ethernet interface
wlan IEEE 802.11b inter-
face
Interface name
Interface configured
ether Ethernet Interface
wlan IEEE 802.11b Inter-
face
Comments to this Manuals