Ricoh SP204SFNW Service Manual Page 232

  • Download
  • Add to my manuals
  • Print
  • Page
    / 308
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 231
Service Calls
SM 6-5 M145/M146/M147/M148/M149/M150/M151
Troubleshooting
Level Definition/ Reset Procedure
C
These are SC codes are not shown. They are logged internally.
Open the Smart Organizing monitor and open the Service Mode screen
to see the SC error log in the Error History box.
D
These SC codes are shown on the M135, M141, M143, M167, M149, M168,
M150, M166, M148, M134, M165, M147, M142, M151, M169, M191
operation panel.
To reset machine, cycle the machine off/on.
The SC codes are re-appear if the error occurs again.
If the problem is in an electrical circuit board, always disconnect then connect the board
connectors again to check for a bad or loose connection before you replace the PCB.
The 2nd column of each table shows the error code that appears in the 2-digit 7-segment
display of the M134, M165, M147, M142, M146, and M164.
SC100: Scanning
SC101
c6
C
CIS Lamp/Scanner Motor
Error
M135, M141, M143, M167,
M149, M168, M150, M166,
M148, M134, M165, M147,
M142, M151, M164, M191
A problem occurred with the CIS or scanner motor in the
flatbed scanner:
After CIS power check
After shading
After CIS failed to return to home position
Flatbed scanner motor connector (main board) loose,
broken, or defective
CIS flat film connector at main board loose, broken or
defective
CIS flat film connector at CIS loose, broken, or defective
Scanner motor defective
CIS defective
Page view 231
1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 307 308

Comments to this Manuals

No comments