SERVICE PROGRAM MODE
SM 5-1 G065
Service
Tables
5. SERVICE TABLES
5.1 SERVICE PROGRAM MODE
!
CAUTION
Before entering the service menu, make sure that the Data In lamp is off. If
the Data In lamp is lit or flashing, wait for it to go off. It will remain on until
the current print job has completed.
5.1.1 ENTERING AND LEAVING THE SERVICE PROGRAM MODE
1. To set the printer in the service mode:
If the printer is off, press and hold down !(Online) and (Escape) then switch
the printer on.
Release the buttons when you see “1. Service” in the LCD.
-or-
If the printer is on, press and hold down
!
and
"
for over 5 seconds and
release.
Press #(Enter). You will see “1. Service” in the LCD. The printer is in the
service mode.
2. Press ! or " to display the menu titles.
1.Service Controller service settings. (☛ 5.2)
2.Engine Engine service settings. (☛ 5.3)
3.End Leave the SP mode and return to normal operation.
3. With the item that you want to open displayed in the LCD, press #(Enter).
4. Press ! or " to display all the menus on the same level, then press #(Enter)
to open the submenus.
5. Press (Escape) to the highest level, ! or " to display “3.End” then press
#(Enter).
Europe North America
G065S902.WMF
Comments to this Manuals