Ricoh SP3510SF User Manual Page 193

  • Download
  • Add to my manuals
  • Print
  • Page
    / 476
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 192
Specifying the Scan Settings
This section describes how to specify the scanning size, image density, and resolution for the current job.
When a scan destination is specified
When you specify a scan destination, the machine's scan settings change automatically according
to the information registered for that destination in the Address Book.
This allows you to send scanned files without having to reconfigure the scan settings according to
each destination. If necessary, you can change the scan settings using the control panel.
The machine maintains the preset scan settings for the current destination until the machine returns
to standby mode.
Changing the preset scan settings for the current destination does not change the information
registered in the Address Book.
If you specify the last used destination, the preset scan settings become effective again, even if you
have changed the settings for the previous job.
Specifying the scanning size according to the size of the original
This section describes how to specify the scanning size according to the size of the current original.
1. Press the [Reduce/Enlarge] key or [Scn Size].
CMF136
2. Press the [ ][ ] keys to select the size of the original, and then press the [OK] key.
If you selected anything other than [Custom Size], you do not need to perform the remaining steps
of the procedure.
3. Press the [ ][ ] keys to select [mm] or [inch], and then press the [OK] key.
4. Enter the width using the number keys, and then press the [OK] key.
To enter a decimal point, press [ ].
Scanning Using the Control Panel
191
Page view 192
1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 475 476

Comments to this Manuals

No comments