9.2 MSU BOARD/BICU BOARD
1. Remove the MSU board [A] (2 screws).
2. Disconnect the connectors from the right half of the IOCSS board,
remove the 4 screws that secure the bracket, and swing out the IOCSS
board.
3. Disconnect all connectors from the BICU board [B] (7 connectors).
NOTE:
When installing the flat cable, push the connector holding the
both ends until it clicks into place.
4. Remove the BICU board (4 screws).
5. Remove the NVRAM [C] from the old BICU board and put it on the new
BICU board.
6. Install the new BICU board and MSU.
[A]
[B]
[C]
A193R522.wmf
OTHERS 1 August 1996
6-36
Comments to this Manuals