Ricoh Printer L4130 User Manual Page 12
- Page / 174
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
xi
CAUTION
Handling of the power cable Power supply
• Connect to a socket-outlet with determinate
polarity.
• For Inlet 1 and 2, be sure to supply power
from the outlet of the same voltage.
• for PLUGGABLE EQUIPMENT, the socket-
outlet shall be installed near the equipment
and shall be easily accessible.
• Unplug the cord from the wall outlet and
remove dust from the power plug
periodically, at least once a year. Failure to
do so may result in fire or electric shocks.
• Do not use the machine unless it is
connected to a power supply that satisfies
the displayed voltage condition.
• Check the voltage of the wall outlet and the
capacity of the circuit breaker before you
plug the power cords. Plug each power cord
to different outlet that has independent
circuit breaker. If you plug more than one
power cord to wall outlets that share the
same circuit breaker, the power may be cut
off by the breaker.
• Leave the breaker turned ON.
• Do not turn off the main power switch on the
right side of this machine.
Handling of ink
• Keep ink away from an open flame. Also
keep the room well ventilated when you use
or handle ink.
• If you get ink in your eyes, immediately wash
your eyes with a lot of clean water for at least
15 minutes. In doing so, also wash eyes to
rinse ink away completely. Then, consult a
doctor as soon as possible.
• If anyone drinks ink by mistake, keep him or
her quiet and see a doctor immediately. Do
not allow him or her to swallow the vomit.
After that, contact the Poison Control Center.
• If you inhale a lot of vapor and feel bad,
immediately move to a location of fresh air
and then keep yourself warm and quiet.
Then, consult a doctor as soon as possible.
• Store ink cartridges in a place that is out of
the reach of children.
• Black and white cause serious eye irritation,
suspected of damaging fertility or the
unborn child, causes damage to the lungs
through prolonged or repeated exposure.
Please use protective equipment in order to
avoid exposure to liquid.
• Orange, green, cyan, magenta and yellow
cause serious eye irritation, suspected of
damaging fertility or the unborn child. Please
use protective equipment in order to avoid
exposure to liquid.
Heater
• Do not spill liquid on the Media Transfer
Surface as this may cause failure of the
heater or firing.
• Do not touch Media Transfer Surface heaters
with bare hand while it is hot; otherwise, you
can get burned.
Note on maintenance
• When cleaning the ink-station or the heads, make sure to wear the attached goggles and gloves.
• The gloves supplied with the machine are disposable. When all the gloves are expended, purchase an
equivalent product on the market.
• Do not to touch the sharp edge of the blade when replacing the cutter. Touching the sharp edge may
result in injury.
• Turn off the machine and unplug the power cord from the wall outlet for safety when moving the
machine.
- Operation Manual 1
- TABLE OF CONTENTS 2
- Chapter 2 3
- Basic Operations 3
- Chapter 3 3
- Extended Functions 3
- Chapter 4 4
- Maintenance 4
- Information 6
- DISCLAIMER OF WARRANTY 7
- FCC Statement (USA) 7
- Warning on Class A Product 8
- DECLARATION OF CONFORMITY 9
- Safety Precautions 10
- Warning for Use 11
- Handling of ink 12
- Note on maintenance 12
- CAUTIONS and NOTES 14
- Cautions on Installation 15
- Safety interlock 16
- Warning labels 17
- Chapter 1 19
- Before Use 19
- Moving This Machine 20
- Names of Parts and Functions 21
- Operation Panel 23
- Signs on the power switch 23
- Media sensor 24
- Carriage 25
- Capping station 26
- Connecting Cables 28
- Connecting the power cable 29
- Inserting ink cartridge 30
- Green and Black inks 32
- Changing an ink cartridge 34
- For Ink cartridge lamps 34
- About ink expiration date 34
- Usable sizes of media 36
- Caution in handling of medias 36
- About antistatic sheet 37
- Workflow 40
- Turning the Power ON/OFF 41
- Turning the Power OFF 42
- Setting a Media 43
- Fix the carriage 44
- Close the front cover 44
- Note for media setting 45
- ERROR 516 46
- MED I A SET POS I T I ON R 46
- MED I A SET POS I T I ON L 46
- Pull out the roll media out 48
- INPUT MEDIA LENGTH 50
- Take-up device 51
- Setting leaf media 52
- Notes when using media press 53
- Changing the printing origin 54
- Preparing for the Heaters 55
- Test Feeding 57
- Test Printing 58
- Head Cleaning 60
- Set the media feeding 61
- Printing Data 65
- Starting a Printing Operation 66
- Drying Feed 67
- Cutting a media 68
- List of Functions 72
- Setting Logical Seek 73
- Setting Drying Time 74
- Setting Margins 75
- (P.2-23) is performed, make 76
- Setting Auto Cleaning 77
- Other Settings 79
- Machine Settings 80
- Setting a AUTO Power-off 81
- Convenient use 83
- Setting Time 84
- Setting Units 85
- Setting a KEY BUZZER 86
- Setting a LANGUAGE 87
- Initializing the Settings 88
- Displaying the Information 89
- Cleaning the Media Sensor 96
- Cleaning the Media Holder 96
- Cleaning the Wiper and Cap 97
- At the start of immersion 98
- At the end of immersion 98
- Cap rubber 100
- Cap rubber cover 100
- Routine Maintenance 101
- Press the key in LOCAL 102
- Press the key 102
- • Never rub the nozzles 106
- COMP LETED [ ENT ] 108
- Close cover 108
- Washing of Head nozzle 109
- Washing nozzle surface 112
- Head No.: H1 to H2 114
- Nozzle line 114
- Reset the set value 116
- (1) Press the key in LOCAL 118
- (4) Press the key 118
- Replacing consumables 120
- Confirmation Message in LOCAL 121
- Replacing the Cutter Blade 124
- Replace the white ink filter 128
- Fill up the white ink 128
- Filling the white ink 130
- Chapter 5 135
- Troubleshooting 135
- Image quality is poor 138
- Nozzle is clogged 139
- Ink cartridge warning appears 139
- When Error 618 to 61b occur 140
- Warning / Error Messages 145
- Message Cause Solution 146
- Ink Error 147
- Error messages 148
- HDC POSCNT 150
- L-SCALE BLACK 150
- SYSTEM HALT 151
- Chapter 6 153
- Appendix 153
- Specifications 154
- Ink specifications 155
- List of consumables 156
- Sheet for inquiry 157
- Function Flowchart 158
- From P.6-6 160
- -9999 to 9999 161
- MAINTENANCE 162
- MACHINE SET 162
- To P.6-14 164
- From P.6-12 166
- 90 to 600 sec 167
- 10 to 90 min 167
- STATION MAINT. / HEAD MAINT 168
- OFF / 1 to 320 169
- Lv.1, Lv.2, Lv.3 170
- MMCC _ _ _ _, _ _ _ _ YYKK 170
- NORMAL / SOFT / HARD 171
Related products and manuals for Print & Scan Ricoh Printer L4130
Print & Scan Ricoh Aficio AP4510 User Manual
(66 pages)
(66 pages)
Print & Scan Ricoh LD117F User Manual
(6 pages)
(6 pages)
Print & Scan Ricoh LDD250 User Manual
(4 pages)
(4 pages)
Print & Scan Ricoh 2045 User Manual
(8 pages)
(8 pages)
Print & Scan Ricoh DSm716 User Manual
(6 pages)
(6 pages)
Print & Scan Ricoh DSC224 User Manual
(6 pages)
(6 pages)
Print & Scan Ricoh Aficio AP400N Setup Guide
(19 pages)
(19 pages)
Print & Scan Ricoh AP4510 Setup Guide
(66 pages)
(66 pages)
Print & Scan Ricoh CL1000N User Manual
(22 pages)
(22 pages)
Print & Scan Ricoh PRO 1357EX User Manual
(12 pages)
(12 pages)
Print & Scan Ricoh AP305 Operations Instructions
(156 pages)
(156 pages)
© 2020, manymanuals.com. All rights reserved. | 0.346 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals