Ricoh Printer L4130 User Manual download pdf (Page 54)

2-16

Setting a Media

Changing the printing origin

The position of the printing origin can be changed.

Moving the LED pointer to the changing position and deciding the position.

In Local, Press .

• It enters into the origin setting mode.

Set a light point of the LED pointer to the changing position by pressing

• Select the carriage and media, moving the point with

• When you press the key here, you can perform

media cutting.

• If the carriage is not covered by the ink cap for a long period

of time, the nozzle face of the head may get dry and

clogged, resulting in white lines being left in the printed

image.

• The buzzer sounds periodically while the carriage is out of

the capping station. The buzzer sounds at shorter interval

when the print heater temperature is high.

After determining the origin, press the key.

• The printing origin is changed.

Typical setting position of printing origin

The printing origin in the depth direction (X') is positioned at about 75 mm rearward from the slot for cutting on

the Media Transfer Surface. The printing origin in the scanning direction (Y') is positioned at 15 mm from the

right end of the media. The value in the scanning direction (Y') can be changed using [MARGIN] in FUNCTION

mode.

( P.3-5) This can be changed by using the Jog key.

OR I G I N SE TUP

0.0 ----

OR I G I N SE TUP

0.0 0.0

Origin

(Length)

Origin

(Width)

OR I G I N SE TUP

** ORIGIN **

slot for cutting

approx. 75 mm

(X’)

25 mm

(Y’)

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 173 174

No comments

Ricoh Printer L4130 User Manual Page 54