2-8
Setting a roll media
1
Move the roll holder located in the back of
the device to the direction of the middle of
the device.
• Loosen the roll holder fixing screw and then move it.
2
Check the clamp lever located in the back of the
device is lowered.
3
Move the roll holder to the roll setting position.
• Check the roll stopper is not caught between the roll stopper arm and this machine.
Roll holder
fixing screw
Roll holder
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
Roll holder
Basis
Setting position
of 3inch tube
Setting position
of 2inch tube
Roll Holder Side
(The back of this machine)
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
Set the base posi-
tion of roll holder
within this range.
• There are two types of the internal diameter
of the roll media paper tube: 2 inch and 3
inch.
• When using a media of greater width, set this so that the media width
can be more inside than .
• If a media is misaligned to the right/left more than fixed position, a
warning is displayed. Set the media again.
Do not set
outside this
mark.
Do not set
outside this
mark.
ERROR 516
MED I A SET POS I T I ON R
ERROR 516
MED I A SET POS I T I ON L
Comments to this Manuals