Ricoh Printer L4130 User Manual download pdf (Page 68)

2-30

Cutting a media

For a roll media, two ways are available to cut the media after printing is completed, as follows.

Press the key.

Press to specify the cutting position.

Press the key.

• The media is cut.

• When the cutting has been completed, the current mode returns to LOCAL.

When [NEAR END] error occurs while printing

The following occurs when [NEAR END] error occurs while printing:

• When each printing has been completed, the current mode returns to LOCAL.

• When each printing has been completed, the current mode returns to LOCAL even if you are making multiple

prints consecutively (cannot perform continuous printing).

• Subsequent printing starts when you press the key, but the current mode returns to LOCAL after

each printing has been completed.

• In order to resume continuous printing, clear [NEAR END] message by performing the following procedure:

(1) Changing an ink cartridge ( P.1-16)

(2) Press the key.

When [INK END] error occurs while printing

• Printing is canceled, and the current mode returns to LOCAL.

• Printing cannot be started while [INK END] warning is being displayed.

• In order to resume printing from where it has been paused, clear [NEAR END] message by performing the

following procedure:

(1) Changing an ink cartridge ( P.1-16)

(2) Press the key.

• When a media is cut, be careful that the printed side does not touch the floor or the printed side of

other already cut media.

• When using the take-up device, take up a cut medium using the switch of the take-up device.

• During the origin setting with the jog keys, you can also perform media cutting by pressing the

key. ( P.2-16)

MED I A CU T

[ENT]

MED I A CU T

CUT POS I T I ON [  ]

CUT POS I T I ON

0.0 ----

** CUTTING **

PLEASE WA I T

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 173 174

No comments

Ricoh Printer L4130 User Manual Page 68