Ricoh 4016 Series User Manual download pdf (Page 31)

ETTING

STARTED

1.20

Using Save Modes

Paper Save

This feature prints 2 pages on a single sheet to save paper. To

turn this feature on, take the following steps:

Press Paper Save. The display shows the current setting

on the bottom line.

Press Paper Save or use

the navigation buttons to change

the setting. To enable the Paper Save mode, select “ON.” Or

select “OFF” to disable the mode.

Press Mode/Enter to save the selection.

OTES

• The Paper Save mode is available only when the document is

loaded in the ADF.

• The Paper Save mode is disabled when you set the collation or

duplex copy options.

Power Save

The Power Save mode allows the printer to reduce power

consumption when it is not in actual use.

You can select the length of time the machine waits after a job

is printed before it switches to a reduced power state.

Press Menu/Exit and then System Data from the one-

touch dial keypad.

Press

until “POWER SAVE” appears on the display.

Make sure that “ON” blinks on the bottom line.

If necessary, use

to select “ON” and press Mode/

Enter.

The available time settings appear on the display and the

current setting blinks. The available options are 5, 10, 15, 30,

and 45 (minutes). Press

until the desired time blinks.

Press Mode/Enter to save the selection.

To return to Standby mode, press Clear/Stop.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 191 192

No comments

Ricoh 4016 Series User Manual Page 31