Fusing
M001 3-18 SM
1. Fusing Lamp [A] ( x 2)
The colored cable must be at the hot roller gear side.
2. Guide plate [B] (3 hooks)
3. Hot roller strippers [C] (1 spring x each)
4. Hot roller [D] (2 x C-rings, 1 x gear, 2 x bushings)
Before removing the hot roller from the unit, remove the gear and the pin first,
Use a small screwdriver to separate the guide plate from the unit.
Before installing the new hot roller, peel off 3 cm (1 inch) from both ends of the
protective sheet on the new hot roller. Be sure to remove the remaining paper
before starting the machine.
Comments to this Manuals