Ricoh SP 311SFN User's Guide download pdf (Page 95)

Specifying the Scan Settings

When you specify a scan destination, the machine's scan settings change automatically according to the

information registered for that destination in the Address Book. If necessary, you can change the scan

settings for the current job using the control panel.

Specifying the Scanning Size According to the Size of the Original

This section describes how to specify the scanning size according to the size of the current original.

1. Press [Scn Size].

2. Press the [ ] or [ ] key to select the size of the original, and then press the [OK] key.

If you selected anything other than [Custom Size], you do not need to perform the remaining steps

of the procedure.

3. Press the [ ] or [ ] key to select [mm] or [inch], and then press the [OK] key.

4. Enter the width using the number keys, and then press the [OK] key.

To enter a decimal point, press [ ].

5. Enter the length using the number keys, and then press the [OK] key.

To enter a decimal point, press [ ].

• You can press the [Escape] key to exit to the previous level of the menu tree.

•

You can change the machine's default [Scan Size] setting to always scan originals with a specific

scanning size. For details, see page 138 "Scanner Features Settings".

• Temporary job settings are cleared in the following cases:

• When no input is received for the period of time specified in [System Auto Reset Timer] while

the initial screen is displayed. For details, see page 166 "Administrator Settings".

• When the [Clear/Stop] key is pressed while the initial screen is displayed.

• When the machine's mode is changed.

• When the power is turned off.

• When the machine's default for the same setting is changed

Specifying the Scan Settings

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 271 272

No comments

Ricoh SP 311SFN User's Guide Page 95