Engine Disassemble Procedure
M085/M086 4-78 SM
3. Remove the Taptite cup S M3x6 SR screw [A], and then remove the FG harness ASSY [B]
from the Laser unit [C].
4. Remove the Taptite cup S M3x6 SR screw [A], and then remove the Air duct [D] from the
Laser unit [C].
When replacing the Laser unit, replace the Serial label [A] attached on the Drive
sub ASSY [B] with the new one supplied with a new Laser unit. If an extra Serial
label is supplied with a new unit as spare. Make sure to throw the spare label away
after replacing the Laser unit, *** it is necessary to input the new Laser unit
characteristics information.*** (
p.4-121 "If You Replace the Laser Unit")
Comments to this Manuals