9. Wind the end of the new wire with a ball as shown in illustrations ② - ④
on the previous page.
10. Wind the end of the new wire with a ring as shown in illustrations ⑤ - ⑦
on the previous page.
11. Secure the screw of the wire tension bracket, with the wire tension spring
pulled as shown in illustration ⑦ on the previous page.
12. Install the 1st scanner and adjust its position with the scanner positioning
tools (P/N A0069104) [A]. Then clamp the 1st scanner with the scanner
positioning pin as shown in illustration ⑧ on the previous page.
13. Remove the positioning tools. After sliding the scanner to the left and
right several times, set the scanner positioning tools to check the clamp
position and wire tension bracket position again.
14. Do the scanner and printer copy adjustments in section 11.
[A]
A193R018.wmf
1 August 1996 SCANNER UNIT
6-17
Comments to this Manuals