FIRMWARE INSTALLATION
SM 4-129 M085/M086
6. If the device driver was successfully installed, the following dialog appears.
Note: The status of the three drivers will be displayed as “Ready to use”.
Click “Finish”.
7. Accessing the "Maintenance Mode"
Connect the machine in Maintenance Mode (Step 2) to your PC using a USB cable.
When the new hardware detection dialog appears, click "Next" to proceed.
When the following dialog appears, select "Install the software automatically
(Recommended)",
and then click "Next" to proceed.
Rev. 11/30/2011
Comments to this Manuals